If you have made the decision to invest in high quality custom adhesive products, chances are you want to get the very most out of your money. Not only this, but you also would probably prefer your bespoke adhesives to do their job properly. Whether ordering from the country’s leading 3M Medical Tape Converters or any other custom adhesive manufacturer, getting the most from your custom adhesive products comes largely down to your own habits.

Now more than ever, businesses spanning a wide variety of industries are making the switch to bespoke adhesive products and moving away from conventional fasteners and fixings. The right adhesive can lead to enormous savings of time, money and effort, while at the same time improving quality of output and making a big difference to overall health and safety. Nevertheless, exactly how well or otherwise these kinds of products perform will always come down to the way they are handled and used.

Here’s a quick rundown of just a few essential pointers on making sure you get the most from your custom adhesive products:

1 – Built for Purpose

First of all, it is crucial to ensure that the adhesive in question is actually compatible with the job at hand. Or in other words, the whole point of using bespoke adhesive products is that they are developed for a specific purpose, as opposed to being one-size-fits-all adhesives. As such, you cannot expect even the most outstanding custom adhesive on the market to do a decent job if it is put to use for a purpose for which it was not created. Even if it does the most fantastic job in certain areas, this doesn’t necessarily mean it will be entirely useless in others. If it wasn’t created specifically for the job in question, don’t use it.

2 – Surface Preparation

Something else to be aware of is the importance of surface preparation, prior to application of any given adhesive products. Unless the surface is adequately prepared in accordance with the instructions provided, it is inevitable that the bond created will not be as strong and reliable as it perhaps should be. From dust to dirt to grease to general imperfections on the surface of the materials to be bonded, the quality of the join will always be determined largely by how well or otherwise the surfaces were prepared.

3 – Ambient Conditions

It’s also a good idea to take into account the ambient conditions, both at the time the adhesive is used and while it is in storage. Each and every custom adhesive will come with its own unique instructions, with regard to how it should be stored. Some must be kept at relatively low temperatures, others should only be used when ambient humidity is relatively low, some perform better if stored in dark places and so on. As such, it’s simply a case of reading the guidelines supplied with a product itself and ensuring they are followed to the letter.

4 – Curing Time

If the instructions supplied with an adhesive state that it needs a full 24 hours before the bond reaches its maximum strength, this doesn’t mean you can take things for granted and give it only 22 hours. Once again, it’s important to remember that these guidelines are there for a reason and therefore should be followed precisely. Each and every custom adhesive will have its own unique curing time, which is why assumptions should never be made with regard to how long it needs. Insufficient time will almost always lead to a substandard or inadequate bond.

5 – Product Age and Condition

As it is the case with almost all products of a similar nature, even the very best custom adhesives have something of a limited shelf life. This is particularly the case when their original packaging/container is first opened, after which there will only be a set period of time within which the adhesive is capable of delivering the same high quality results. Shelf life varies significantly from one product to the next and will always be specified, either on the packaging itself or in the instructions provided.

6 – Subsequent Treatment

Last but not least, it is also important to bear in mind that the treatment and conditions the bond is subject to after being created will make a big difference to its reliability and performance. The ambient conditions in a sauna for example are considerably different from those of a public park. It’s therefore a case of thinking about not only what it is that needs to be joined, but how the product or item in question is to be used going forward.

 

      Say your opinion about the watch

You must be logged in to post a comment.